Здравствуйте!
Следуя инструкциям
http://www.zao-zeo.ru/dokuwiki/doku.php/linux собрали в buildroot-2009.08 КФС и ядро linux-2.6.20.21. Ядро и КФС собрано с EABI.
Ядро работоспособно, но после монтирования корневого раздела проблема с КФС - init не стартует. /etc/inittab стандартный, /etc/fstab стандартный, никакие файлы не правились, патчи использовались с вашего сайта. В чем может быть проблема?
U-Boot 2010.09-00000-gbd6c472 (Jan 11 2011 - 09:56:21)
DRAM: 64 MiB
Flash: 64 MiB
In: serial
Out: serial
Err: serial
Net: ep93xx_eth-0
Hit any key to stop autoboot: 0
## Booting kernel from Legacy Image at 60080000 ...
Image Name: Linux-2.6.20.21
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 2033488 Bytes = 1.9 MiB
Load Address: 00008000
Entry Point: 00008000
Verifying Checksum ... OK
Loading Kernel Image ... OK
OK
Starting kernel ...
Uncompressing Linux...
Linux version 2.6.20.21 (u509@Lab52) (gcc version 4.3.4 (GCC) ) #3 PREEMPT Fri Aug 24 15:08:38 MSK 2012
CPU: ARM920T [41129200] revision 0 (ARMv4T), cr=c0007177
Machine: Tion-Pro2 Board
Memory policy: ECC disabled, Data cache writeback
CPU0: D VIVT write-back cache
CPU0: I cache: 16384 bytes, associativity 64, 32 byte lines, 8 sets
CPU0: D cache: 16384 bytes, associativity 64, 32 byte lines, 8 sets
Built 1 zonelists. Total pages: 16192
Kernel command line: rootdelay=5 console=ttyAM0,57600 video=ep93xxfb:vout=1,vmode=18 root=/dev/sda1
PID hash table entries: 256 (order: 8, 1024 bytes)
Console: colour dummy device 80x30
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 32MB 32MB = 64MB total
Memory: 60664KB available (3316K code, 778K data, 116K init)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
NET: Registered protocol family 16
ep93xx: PLL1 running at 399 MHz, PLL2 at 192 MHz
ep93xx: FCLK 199 MHz, HCLK 99 MHz, PCLK 49 MHz
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 2048 bind 1024)
TCP reno registered
audit: initializing netlink socket (disabled)
audit(0.340:1): initialized
NTFS driver 2.1.28 [Flags: R/W].
JFFS2 version 2.2. (NAND) (C) 2001-2006 Red Hat, Inc.
io scheduler noop registered (default)
io scheduler deadline registered
io scheduler cfq registered
ep93xx-backlight ep93xx-backlight.0: initialized
ep93xxfb_get_par: TFT 640x480 5.7"
Console: switching to colour frame buffer device 80x30
fb0: EP93xx frame buffer at 640x480x16bpp
ep93xx_wdt: EP93XX watchdog, driver version 0.3
Serial: AMBA driver $Revision: 1.41 $
RS485 hardware flow control on 3rd serial port
apb:uart1: ttyAM0 at MMIO 0x808c0000 (irq = 52) is a AMBA
apb:uart2: ttyAM1 at MMIO 0x808d0000 (irq = 54) is a AMBA
apb:uart3: ttyAM2 at MMIO 0x808e0000 (irq = 55) is a AMBA
RAMDISK driver initialized: 2 RAM disks of 32768K size 1024 blocksize
loop: loaded (max 8 devices)
nbd: registered device at major 43
PPP generic driver version 2.4.2
PPP Deflate Compression module registered
PPP BSD Compression module registered
PPP MPPE Compression module registered
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx
Cirrus Logic EP93XX IDE initialization.
physmap platform flash device: 03ff0000 at 60000000
physmap-flash.0: Found 2 x16 devices at 0x0 in 32-bit bank
NOR chip too large to fit in mapping. Attempting to cope...
Intel/Sharp Extended Query Table at 0x010A
Intel/Sharp Extended Query Table at 0x010A
Intel/Sharp Extended Query Table at 0x010A
Intel/Sharp Extended Query Table at 0x010A
Intel/Sharp Extended Query Table at 0x010A
Using buffer write method
Using auto-unlock on power-up/resume
cfi_cmdset_0001: Erase suspend on write enabled
Reducing visibility of 65536KiB chip to 65472KiB
RedBoot partition parsing not available
Using physmap partition information
Creating 3 MTD partitions on "physmap-flash.0":
0x00000000-0x00080000 : "bootloader"
0x00080000-0x00300000 : "kernel"
0x00300000-0x03fc0000 : "rootfs"
ep93xx-spi ep93xx-spi.1: SPI controller initialized
ep93xx-usb ep93xx-usb: EP93xx OHCI
ep93xx-usb ep93xx-usb: new USB bus registered, assigned bus number 1
ep93xx-usb ep93xx-usb: irq 56, io mem 0x80020000
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 3 ports detected
Initializing USB Mass Storage driver...
usb 1-3: new full speed USB device using ep93xx-usb and address 2
usb 1-3: not running at top speed; connect to a high speed hub
usb 1-3: configuration #1 chosen from 1 choice
scsi0 : SCSI emulation for USB Mass Storage devices
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
usbcore: registered new interface driver hiddev
usbcore: registered new interface driver usbhid
drivers/usb/input/hid-core.c: v2.6:USB HID core driver
usbcore: registered new interface driver usbserial
drivers/usb/serial/usb-serial.c: USB Serial support registered for generic
usbcore: registered new interface driver usbserial_generic
drivers/usb/serial/usb-serial.c: USB Serial Driver core
drivers/usb/serial/usb-serial.c: USB Serial support registered for FTDI USB Serial Device
usbcore: registered new interface driver ftdi_sio
drivers/usb/serial/ftdi_sio.c: v1.4.3:USB FTDI Serial Converters Driver
drivers/usb/serial/usb-serial.c: USB Serial support registered for pl2303
usbcore: registered new interface driver pl2303
drivers/usb/serial/pl2303.c: Prolific PL2303 USB to serial adaptor driver
mice: PS/2 mouse device common for all mice
m41t00 0-0068: rtc core: registered m41t00 as rtc0
Registered led device: ep93xx:green
Registered led device: ep93xx:red
TCP cubic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
NET: Registered protocol family 15
m41t00 0-0068: setting the system clock to 2012-08-24 03:36:48 (1345779408)
Waiting 5sec before mounting root device...
scsi 0:0:0:0: Direct-Access Kingston DataTraveler 102 PMAP PQ: 0 ANSI: 0 CCS
SCSI device sda: 7819264 512-byte hdwr sectors (4003 MB)
sda: Write Protect is off
sda: assuming drive cache: write through
SCSI device sda: 7819264 512-byte hdwr sectors (4003 MB)
sda: Write Protect is off
sda: assuming drive cache: write through
sda: sda1
sd 0:0:0:0: Attached scsi removable disk sda
VFS: Mounted root (ext2 filesystem).
Freeing init memory: 116K
init 3.0.3 (18 MKernel panic - not syncing: Attempted to kill init!
ay 2009)
No dev ice specified!
Usage: mkdosfs [-A] [-c] [-C] [-v] [-I] [-l bad-block-file] [-b backup-boot-sector]
[-m boot-msg-file] [-n volume-name] [-i volume-id]
[-s sectors-per-cluster] [-S logical-sector-size] [-f number-of-FATs]
[-h hidden-sectors] [-F fat-size] [-r root-dir-entries] [-R reserved-sectors]
/dev/name [blocks]
Автор
Тема: Tion-Pro v2 rev3 (Прочитано 23325 раз)